Tel: (51-1) 717-8340





 High density pasted plates for high cycle life

Nano-Carbon enhanced active material to maximize cycle performance and PSoC operation

Low calcium Lead/Tin alloy plates for efficient gas recombination for long life in both cycling and float applications

Absorbent Glass Mat (AGM) technology for efficient gas recombination of up to 99% and freedom from electrolyte maintenance

Multicell design for economy of installation and maintenance

Front Access threaded copper alloy inserts for reduced maintenance and increased safety

Terminal versatility - ease of diagnostic readings with C&D Ohmin Ring

Reduced headspace driving higher energy density, in cabinet or rack applications

Can be used in any orientation. Upright, side, or end mounting recommended

High-strength, leak-free polymer container allows for non-restricted shipping;

Water: non-hazardous per IMDG Amendment 27

Surface: non-hazardous per DOT-CFR title 49,

171-189 Air: IATA/ICAO, provision A67

UL-recognized component

Battery hardware and removable carrying handles included

Meets IEC 61421 for PV applications

Multitier racks and cabinets available


Cells Per Unit

Nominal Voltage Per Unit



159 lbs (72.0 kg)

Discharge: -40°F (-40°C) to +160°F (71°C)

Charge: -10°F (-23°C) to +140°F (60°C)

Operating Temperature Range

Optimal Operating

Temperature Range

+74°F (23°C) to +80°F (27°C)

Recommended Maximum Charging

Current Limit

30 amperes per 100Ah @ C20 (62.4A)

Float Charging Voltage

13.62 to 13.8 VDC/unit Average at 77°F (25°C)

Equalization and

Cycle Service

Charging Voltage


14.4 to 14.8 VDC/unit Average at 77°F (25°C)

Maximum AC Ripple

0.5% RMS or 1.5% P-P of float charge voltage recommended for best results

Maximum voltage allowed = 4% P-P

Maximum current allowed = C20 RMS (20 Amps)


Self Discharge

Up to 6 months at 77°F (25°C) and then a freshening charge is required.

Batteries stored at temperatures at greater than +77°F (25°C) will require recharge

sooner than batteries stored at temperatures less than 77°F (25°C).

See C&D bulletin 41-7272, Self Discharge and Inventory Control for details



Factor (Charging)

+3 mv/F per cell when operating, below 77°F (+25°C)

-3 mv/F per cell when operating, above 77°F (+25°C)



Threaded copper alloy insert terminal to accept 5/16´´ - 18 bolt

Terminal Hardware

Initial Torque

160 in.-lbs (18 N-m)

The VR Solar Front  Access, with its grid alloy and DCS Technology, coupled with an advanced Nano-Carbon enhanced negative electrode provides time proven results and unmatched, industry leading cycle life even in partial state of charge (PSoC) operation. This VRLA/AGM baterry is designed to be easy to install and maintain, and offers long life and exceptional performance.

Copyright 2005-2015 LGT SOLAR EIRL.

LGT Solar E.I.R.L    Av. La Molina 3443 Oficina 10 La Molina Lima, Perú